主控板 - VS11SRP1N0

1  单板标识

单板前面板右上角标有丝印：VS11SRP1N0，用来标识该单板。

2  单板简介

VS11SRP1N0单板上依次排列有CF卡接口、CF卡状态指示灯（CFS）、10Base-T/100Base-TX接口、RS232/485口、Console口、AUX口、系统复位键、业务板/接口板状态指示灯、VS11SRP1N0状态指示灯（SFS、ACT、ALM、RUN）。

                                                                                                                                                                               表1 单板属性

属性	规格
接口连接器类型	RJ45
对外接口	1个Console口，支持交换机的本地配置管理 1个AUX口，支持交换机的远程拨号配置管理 1个升级、网管用10Base-T/100Base-TX接口 1个RS232/485口，保留使用 1个CF卡接口
接口传输速率	Console口：≤115200bit/s，缺省为9600bit/s AUX口：≤38400bit/s，缺省为9600bit/s 10Base-T/100Base-TX接口：10M/100M、半双工/全双工、MDIX
可选用线缆及最大传输距离	Console口：普通异步串行口电缆，传输距离≤15m AUX口：普通异步串行口电缆，传输距离≤15m 10Base-T/100Base-TX接口：5类双绞线，传输距离≤100m
单板适用的机型	UMS9005
单板适用的主机软件版本	UMS9000-B1110及以上版本

 

3  注意事项

如主机软件版本不匹配，请联系该设备的销售商或集成商获取相应的主机软件版本。

单板安装说明及主机软件版本的升级方法请参见《H3C UMS9000系列通用媒体交换机  安装手册》相关章节。

 

 

杭州华三通信技术有限公司

Switch Routing Process Card - VS11SRP1N0

1  Card Identifier

The silkscreen VS11SRP1N0 is printed at the upper right corner of the front panel to identify the card.

2  Specifications

On the front panel of VS11SRP1N0, CF port, CF LED (CFS), 10Base-T/100Base-TX port, RS232/485 port, Console port, AUX port, RESET button, LPU status LEDs, VS11SRP1N0 status LEDs (SFS, ACT, ALM, RUN) are arranged from left to right.

Table1  Card specifications

Item	Specification
Connector	RJ45
External Ports	One Console port, for local configuration management One AUX port, for remote dialup configuration management One 10Base-T/100Base-TX port for system management and program upgrade One RS232/485 port, reserved One CF port
Transmission rate	For Console port: no more than 115200bit/s, 9600bit/s by default For AUX port: no more than 38400bit/s, 9600bit/s by default For Ethernet Interface: 10Mbps/100Mbps, half/full duplex, MDIX
Cable and maximum transmission distance	For Console port: asynchronous serial cable with maximum transmission distance 15m. For AUX port: asynchronous serial cable with maximum transmission distance 15m. For 10Base-T/100Base-TX interface: Category 5 UTP with maximum transmission distance 100m.
Applied to	UMS9005
Host software version	Version UMS9000-B1110 and above

 

3  Note

If the host software version does not match the one applicable to the card, contact the vendor or the integrator for the right version.

For the introduction of card installation and host software upgrade, see the related part in H3C UMS9000 Series Universal Media Switches Installation Manual.

 

 

Hangzhou H3C Technologies Co., Ltd.